Standing Seam Metal Roofing
The Benefits of Installing Standing Seam Metal Roofing
Standing seam roofing was created for sloped roofs. The pre-fabricated panels have dimensions of both 14 and 18 inches wide. This gives them stability to handle the slope. They are attached mechanically using double-locking devices which tighten the seams and make the entire layout both air and water tight. Immovable copper cleats secure the metal panels to the deck. This eliminates any potential for the roofing system to slide off the roof.
Commercial Metal Roofing Companies Sulphur Springs Tx
One of the challenges of bringing standing seams panels together is concealing the fasteners. The solution was covered fasteners. The seams were raised to cover the fasteners without damaging the roof. There are no puncture or hole in the decking. This eliminates any need for leak repair in the future. The metal holds up well under weather conditions. It’s flexible, robust, and seems to last forever. An added bonus to standing seams is that do not allow ice dams to form during the East Texas winters. This protects the roof along the edges and reduces added weight to the decking.
By installing standing seam roofing, you give your entire roofing system the protection it needs to last year after year. Standing seams provide a layer of defense for critical areas like valleys, eaves, chimney areas, fascias, and soffits. When the weather is at its worst, standing seams continue to shield the roof from torrential rains, blustery winds, hail, and scorching sunlight and heat. And the best part is that you can depend on standing seam metal roofing to perform this well over the course of five decades. This destroys the competition.
Best Roofing Contractors Sulphur Springs Tx.
When it comes to installation, standing seam metal panels do not follow suit with conventional metal panels. While V-Panels and T-Panels can be implemented using the over the top method, standing seam require a clean palette. Everything has to be removed the decking with a clean surface to work from.The process of installation begins with an inspection of the roof to determine any previous damage. Roof repairs, leak repairs, and other types of roofing maintenance may need to be performed. From there, the eaves are trimmed, and new flashing is laid down to replace the old flashing. From there the underlayment is rolled out.